The most fundamental reason why dispensing machine can not keep glue is that the seals are not leaking, and the suction of the leak valve does not play any role, which will lead to bad glue recovery and leakage. Glue will be the problem mentioned above. W.
With the continuous improvement of automobile manufacturing technology and peoples requirements, new energy vehicles are included in the production of most automobile enterprises, and peoples daily application is also increasing. The electric vehicle driv.
The function of the trumpet mixing pipe used in the automatic glue filling machine is very simple. Only two functions are needed to control the amount of glue produced and improve the mixing degree of the two components glue. If there are other functions,.
The automatic dispensing machine has the functions of high viscosity, small glue point, and wire drawing phenomenon controlled. If the viscosity of the automatic dispenser is small, the glue may infiltrate into the product. Therefore, the adaptive viscosi.
For automation equipment, attention must be paid to the operation details. If the operation is not good, it will lead to problems of the equipment used. For example, the poor operation details of high-speed dispensing machine will affect the operation per.
1 glue volume According to working experience, the problem of dispensing equipment is mainly related to the amount of glue. The diameter of the adhesive spot should be half of the distance between the pads, and the diameter of the adhesive spot after patc.
Why use quick-drying glue dispenser? Improve work efficiency, dispensing environment and quality of dispensing Precision control of glue volume, avoid excessive glue waste, automatic removal of glue to prevent needle clogging Compared with ordinary stainl.
The dispensing control of automatic dispensing machine and glue filling machine is a common problem in packaging industry. The quantity of dispensing glue and the application time of filling glue have an effect on the quality of packaging products. 1. Pre.
Are you still worried about dispensing as a consumer? Are you still using manual dispensing? Manual dispensing not only wastes raw materials, but also has a bad effect. It often wastes a lot in maintaining a clean shell. Have you ever thought of replacing.
In recent years, with the rapid development of automation equipment, the degree of automation is relatively high. In the past few years, every part of automatic dispensing machine has been upgraded continuously, the function of intelligent recognition of .